Classical mattresses are generally more rigid than foam mattresses. On the other hand, the foam mattress requires specific packing and care to avoid damage during shipment. Most foam mattresses contain two or more layers that are stacked on top of each other. Improper packing or handling of the foam can easily separate the layers and pull them apart. You can get memory foam mattress king online.
Follow the steps outlined below to move a memory foam mattress from one location to another and read some helpful hints.
Seal the corner of the mattress shipping container, which must be sized to suit the mattress, and then seal it with packing tape. Moving a memory foam mattress in an overly big box might cause movement and probable damage while moving it in a bit of a box might easily crush the mattress. Instead, place the box on a level surface near one end of the memory foam mattress, with the open end towards the memory foam mattress.
Wrap the top part of the box around one end of the foam mattress. If necessary, the user should keep sliding the box until it is filled with the mattress. In many circumstances, the user is needed to raise and adjust the mattress components while sliding the box. Inside the box, the mattress must be entirely flat, with no folds or creases.
Finally, close the box’s open end and transfer the mattress flat. Again, it is not a good idea to stand the box upright on any of the edges.
Initially, insert the mattress in the bag; if the user has the correct bag size, the foam mattress should glide in smoothly, like a card that fits inside an envelope.
Choose a sealable bag to seal the package because it will be much easier to deal with. In this stage, the user must ensure that the bed is securely fastened and sealed on the inside. Even when utilizing a sealable bag, the user should apply duct tape to strengthen the edges twice or even three times.
Tape the valve from the vacuum bag to the ordinary plastic as well. After that, cut a hole in the plastic to allow the valve to pass through and reach the bed’s surface. Tape the hole as firmly as possible so that it is airtight when vacuuming.
Vacuum the air out, connect the vacuum line to the valve, and turn on the vacuum to start the procedure. Slowly, all of the air will be drawn out, and the mattress will begin to compress to a fraction of its previous height.
After flattening the mattress as much as possible, roll it up in a horizontal configuration to begin the rolling procedure. Again, it’s a good idea to keep the vacuum running while rolling to ensure there’s no air trapped within.
Strap it down and use the ratchet straps to secure the mattress securely. The straps are necessary because if the plastic holding everything together tears or breaks, the bed will remain coiled and crushed.
Important and Practical Tips
Standing a carton foam mattress on its side can easily split the foam layers, resulting in irreversible damage. If a firm is carrying the foam mattress, it is good to mark the box to inform the movers that it must be kept flat. Even a single turn of the box in the upright position might cause the foam to slip and compress within the box.
Foam mattresses tend to adhere to a variety of surfaces. Wrap the mattress with huge sheets if it adheres to the box. This will help it to slip in smoothly.
If you need to transport the foam down a flight of stairs or around an obstruction that prevents the box from being level, carry the mattress past the impediment before packing it.